Who this is for: A business experiencing drafts, water, noise, or light around an exterior door.

When draughts point to a bigger problem

Worn weather-stripping is common and easy to replace. But if the gap is uneven, wider at the top on one side, or the door no longer latches, the door has likely dropped on its hinges or pivots. Replacing seals without fixing the hang will not last. A quick check of the gaps around the door usually shows which problem you have.

A practical checklist

  1. Inspect the perimeter, threshold, hinges, closer, and latch engagement.
  2. Note whether the draft changes when the door is latched or held open.
  3. Ask for compatible weather-stripping and an alignment check.
  4. Test the seal, latch, and safe egress after installation.

Common mistake to avoid

Adding a thick seal can make an already misaligned door harder to close and lock.

What is different in Toronto

Toronto snow, salt, wind, and high foot traffic can wear seals quickly; the root cause should be recorded with the replacement.

Find out where the air is coming in

Close the door, turn off the lights in the room and shine a flashlight along the edges from outside, or use a piece of paper to test the seal. Gaps at the bottom, at the meeting stile of double doors or along the hinge side show where the seal has failed.

When weather-stripping is enough

Worn bulb seals, brush sweeps and door bottoms can be replaced cheaply. This is the right fix when the door is straight and closes properly.

When the door needs more

A door that has dropped on its hinges, a closer that does not pull the door tight or a warped frame will let air in no matter how new the seals are. In that case, fix the alignment first. A tight door also protects the lock and reduces wear. See door closer winter adjustments and door alignment problems.

Need help with commercial door weather sealing? Better Call Locksmith Toronto operates 24/7 from 901 Yonge Street. See our commercial door and lock service page or call (416) 240-0593.